TEVO 3D Printer parts MKS Gen V1.4 Motherboard 3D Printer Control Board With USB Mega 2560 R3 Motherboard RepRap Ramps1.4 for

Regular price $45.68 Save $-45.68
/

Only 9985 items in stock!

MKS gen V1.4 3D Printer Control Board With USB Mega 2560 R3 Motherboard RepRap Ramps1.3 Compatible for TEVO 3D Printer parts

 

Product name: Motherboard MKS Gen V1.4

3D printer controller board MKS-Gen V1.4 Special Note:
1, before powering up again confirm whether the positive and negative reversed, if the user is due to reverse power and burn, and we do not guarantee such problems!
2, Do not plug in case of power motor and drive, drive easily lead to burn; do not adjust the current in the motor is running. The correct approach is to first disconnect the power, unplug the motor, and then re-power, adjust potentiometer, measure the voltage on the potentiometer until the measured voltage is the same as expected. Do not insert anti-drive, otherwise it will burn drive, or even burn out the motherboard.
Attention:
1, please confirm whether the positive and negative repeatedly before electricity, if it is due to reverse power users and burn, this kind of problem we don't guarantee!
2, please don't in the electric plug motor and drive, easy to cause the drive burnt out; don't in the running process of the motor, adjustable current. The correct approach is to disconnect the power, unplug the motor, re power, potentiometers, measuring potentiometer voltage, until the measured voltage and expected the same. Never in reverse drive, otherwise it will burn driven, even burn out the motherboard!
Characteristic advantage:
1, the 2560 and ramps1.4 set on a board, to solve the complex Ramps1.4 combination interface, easy to trouble the problem.
2, can be replaced by motor drive, support 4988 drive and 8825 drive, TMC2100 drive
3, the circuit board uses the high quality 4 board, and has been specially made the heat radiation optimized processing; ramps is 2 laminates.
4, the use of high quality MOSFET tube, the cooling effect is better.
5, the use of dedicated power chip, support 12V-24V power input, to solve the problem of Ramps voltage conversion chip.
6, you can accept the 24V input, the same system power can be reduced to the thermal bed current 1/4, effectively solve the problem of hot bed MOS tube heating.
7, the firmware can use the open source firmware Marlin, configuration and ramps1.4 exactly the same, can be directly replaced by Ramps1.4.
8, can be directly connected to the Ramps1.42004LCD control board and 12864LCD control board.
9, set aside the motor pulse and the direction of the output port, to facilitate the external large current external to connect a large current (such as 5A, 2A) motor drive circuit.
10, keep the Servos on the Ramps1.4, AUX-1, AUX-2 interface, providing 3 5V outputs, 3 12V output interface.

Packing list:

Motherboard MKS Gen V1.4*1(dont contain the DRV8825)

UBS Cable*1

 

 

 

 

 

• Payment Method
If you have any trouble with payment ,please contact us . We can accept any payment method you would like to choose .
 

• Quality Warranty

1.Please contact us if you have any problem of quality .

2.90 Days of quality warranty .

3.Defective items must be returned within the warranty period.
 
•Feedback
 Feedback is very important for us.We appreciate your positive feedback if you are statisfy with our products and service.
 
Please contact us before leaving any negative or neutral feedback. We will solve any problem in 24hous.