Thermal Runaway above 224C


  • Fun times, lemme tell you. I got a Thermal Runaway Error E1 when printing with a PLA, ranged 215-235. Because of some gaps in the first layer on my first go-around at 220C,  I set Cura to 230C and tried again. After a few layers, I got the Thermal Runaway E1 message, reset the printer and tried again. Same error, much later in the print. 225C resulted in the same error.

     

    The highest nozzle temp I can complete a print with is 222C. Normally I'm closer to 200C, but I should be able to go all the way up to 240C? 



  • Seria bom você atualizar o firmware, estou com este problema  na Cama aquecida,  vou ver se consigo reescrever os prametros dela para melhorar esta questão, por que quero imprimir ABS e nao estou conseguindo 


Please login to reply this topic!